Avoid Drone Program Risk: Solve Potential DFM Issues Now
Sidestep Production Headaches & Costly Delays
A big source of risk is any new defense program is component manufacturability. From part geometry, wall thicknesses and tolerances to materials, finishing and assembly, these unseen problems can:
- Cause costly, time-consuming rework,
- Destroy your tight production schedule and
- Even result in dangerous in-field failures.
Solve These Challenges with Our New Guide
Our new DFM Red Flag Diagnostic guide helps you anticipate critical design for manufacturability (DFM) issues during the part design and prototyping process, when they’re easier and much less expensive to fix.
Doing so when your parts are in production can cost significantly more – worse yet, it can delay your launch for weeks. You can’t afford that!
This 13-page engineering and design resource contains:
- Summaries of 50 common DFM issues
- The problems they can cause and
- Tips on how to solve them.
It’s laser-focused on the manufacturing technologies commonly used in drone production – plus assembly, finishing and inspection.
Don’t wait until production to discover part design problems that could derail your launch.
Anticipate and solve them now with this guide!
